Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 178
After writing an entry into the log, you are prompted to clear the display. The default name of the saved
file is DiagTest.log. An example of a saved log file appears below:
Figure 110: Example of a DiagTest.log window
To save the log file:
1. After running a test from the Diagnostic Test Setup dialog box, click Save to File. The Select
Diagnostic Log file Name dialog box appears. The default name of a saved file is DiagTest.log.
2. Browse to the desired directory, change the log file name if you want and click Save.
OneConnect Diagnostics
This section describes the diagnostics for OneConnect adapters. For FC adapter diagnostics, see
“LightPulse FC Diagnostics” on page 168.
Use the Diagnostics tab to:
• Run these tests on OneConnect adapters installed in the system:
• DMA Loopback
• PHY Loopback
• MAC Loopback
• End-to-End (ECHO) (FCoE only)
• External Loopback
• Perform a diagnostic dump and retrieve dump files from remote hosts.
• Control adapter beaconing
Note: Diagnostics are not available in read-only mode. See “Changing Management and
Read-Only Mode” on page 28 for more information.