Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 191
Commands Supported in Target-mode Ports
Parameters Not Supported in the CIM Interface
The following parameters are not supported ESX 3i U4 via CIM Provider v 2.0.9.x:
• HbaAttributes
• Opt ROM Version
• Operational FW
• ServerAttributes
• FW Resource Path
• DP Resource Path
Read-Only Mode
The OneCommand Manager CLI does not allow the execution of certain commands when it is
configured for read-only mode. An error message returns if such a command is attempted:
Error: Read-only management mode is currently set on this host. The requested
command is not permitted in this mode.
Note: The following HbaCmd commands are supported for managing target-mode ports:
DeleteDumpFiles
Download
DriverConfig
ExportSanInfo
GetDCBParams
GetDriverParams
GetDriverParamsGlobal
GetDumpDirectory
GetFCFInfo
GetFIPParams
GetPGInfo
GetPortStatistics
GetRetentionCount
GetVPD
GetXcvrData
HbaAttributes
ListHBAs
PortAttributes
Reset
SaveConfig
ServerAttributes
SetDCBPGBW
SetDCBParam
SetDriverParam
SetDriverParamDefaults
SetFIPParam
SetPortEnabled
SetRetentionCount
All other HbaCmd commands return the error message:
"Not Supported for Target Mode Adapters."