Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 204
OneConnect adapter parameters: (1= enabled 0 = disabled)
DCBXState - The current DCBX (Data Center discovery and Capability exchange protocol)
state
DCBXMode - The DCBX mode can be either DCB or CIN.
PFCEnable - Enabled means that flow control in both directions (Tx and Rx) is enabled.
FCoEPriority - You must specify a single priority (0-7). [only for FCoE adapters]
iSCSIPriority - You must specify a single priority (0-7). [only for iSCSI adapters]
PFCPriorities - Specify PFCPriorities as a single priority or as a list of comma separated val-
ues. Comma separated list of up to 7 values ranging from 0-7.
Default - Setting the SetDCBParam arguments to default sets all CNA DCB params (includ-
ing priority groups) to their default values.
For example:
hbacmd SetDCBParam <WWPN|MAC> defaults
Link Layer Discovery Protocol (LLDP) parameters:(1= enabled 0 = disabled)
TxState (Transmit State)- DCBX uses Link Layer Discovery Protocol (LLDP) to exchange
parameters between two link peers. For the DCBX protocol to operate correctly, both LLDP
Rx and Tx must be enabled. If either Rx or Tx is disabled, DCBX is disabled.
RxState (Receive State) - DCBX uses LLDP to exchange parameters between two link
peers. For the DCBX protocol to operate correctly, both LLDP Rx and Tx must be enabled. If
either Rx or Tx is disabled, DCBX is disabled.
TxPortDesc (Transmit Port Description)- Provides a description of the port in an alpha-
numeric format. The value equals the ifDescr object, if the LAN device supports RFC 2863.
TxSysDesc (Transmit System Description)- Provides a description of the network entity in
an alpha-numeric format. This includes the system's name and versions of hardware, oper-
ating system and networking software supported by the device. The value equals the sysDe-
scr object, if the LAN device supports RFC 3418.
TxSysName (Transmit System Name) - Provides the system's assigned name in an alpha-
numeric format. The value equals the sysName object, if the LAN device supports RFC
3418.
TxSysCap (Transmit System Capabililities) -Indicates the primary function(s) of the device
and whether or not these functions are enabled on the device. The capabilities are indicated
by two octets. Bits 0 through 7 indicate Other, Repeater, Bridge, WLAN AP, Router, Tele-
phone, DOCSIS cable device and Station respectively. Bits 8 through 15 are reserved.
Where multiple values are possible, specify them with a comma-separated list.
Example:
# hbacmd h=10.192.203.151 m=cim u=root p=Swamiji001 n=root/emulex setdcbparam
00-00-c9-3c-f7-88 fcoepriority 3
Note: The OneConnect adapter parameters doe not apply to LP21xxx adapters.
Note: DCBX mode also configures FIP mode. If DCBX mode is DCB, FIP is enabled. If it is
CIN, FIP is disabled.