Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 206
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the NIC or iSCSI port
PFCPriorities - PFC priority that is a comma separated list of up to 7 values ranging from 0-7.
Priorities of PGID - Priority group membership that is a comma separated list of priorities rang-
ing in value for 0-7.
Example:
hbacmd h=10.192.203.151 m=cim setdcbpriority 10:00:00:00:c9:3c:f7:88 3
0,1,2,4,5,6,7 3 0 0 0 0 0 0
Diagnostic Commands
EchoTest
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd EchoTest <WWPN Source> <WWPN Destination> <Count> <StopOnError> <Pattern>
Description: This command runs the echo test on adapters.
Parameters:
WWPN Source - WWPN of the originating adapter
WWPN Destination - WWPN of the destination (echoing) adapter
Count - Number of times to run the test (0 = run test indefinitely)
StopOnError - Checks if the test must be halted on error
0 = No halt
1 = Halt on error
Pattern - Hexadecimal data pattern to transmit (up to 8 characters)
GetBeacon
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd GetBeacon <WWPN|MAC>
Description: This command shows the current beacon state, ON or OFF.
Note: This command is not supported for OneConnect adapters.
Note: Support for remote adapter is TCP/IP access only. The EchoTest command
fails if the target WWPN does not support the ECHO ELS command.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 244.