Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 210
Output:
Vendor ID: 0x19A2 Device ID: 0x0700
Command: 0x0406 Status: 0x0010
Revision ID: 0x02 Prog If: 0x00
Subclass: 0x00 Base Class: 0x02
Cache Line Size: 0x10 Latency Timer: 0x00
Header Type: 0x80 Built In Self Test: 0x00
Base Address 0: 0x00000000 Base Address 1: 0xDF478000
Base Address 2: 0xDF480004 Base Address 3: 0x00000000
Base Address 4: 0xDF4A0004 Base Address 5: 0x00000000
CIS: 0x00000000 SubVendor ID: 0x10DF
SubSystem ID: 0xE622 ROM Base Address: 0x00000000
Interrupt Line: 0x00 Interrupt Pin: 0x01
Minimum Grant: 0x00 Maximum Latency: 0x00
Capabilities Ptr: 0x40
PostTest
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd PostTest <WWPN>
Description: This command runs the POST on the adapter. Support for a remote adapter is via TCP/IP
access only.
Parameters:
WWPN - Adapter’s WWPN
SetBeacon
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd SetBeacon <WWPN|MAC> <BeaconState>
Description: This command turns the beacon ON or OFF.
Parameters:
WWPN - WWPN of the FC port
MAC - MAC address of the NIC or iSCSI port
Note: Not supported for OneConnect adapters.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 244.