Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)
The OneCommand Manager User Manual Page 57
After the system overheating issue is resolved and the adapter has cooled down, reboot the
system or, if the system supports hot swapping, cycle the power of the adapter slot.
Viewing OneConnect Adapter Information
When you select a OneConnect adapter from the discovery-tree, the Adapter Information tab contains
general attributes associated with the selected OneConnect adapter. You can also use this tab to view
and enable licenses. See “Showing and Installing Licenses for OneConnect Adapters” on page 95 for
more information.
To view general OneConnect adapter information:
1. Select Host view.
Note: If you are running the OneCommand Vision application, you must stop the
OneCommand Vision sensor before hot-swapping an adapter or the hot-swap will
fail.
To stop the sensor:
1. Select Start > Programs > Administrative Tools > Services.
2. Stop the EmulexSensor service.
3. Stop the EmulexWMIAgent service.
4. Stop the Emulex PDH agent service.
5. Stop the EmulexScope agent service.
To restart the sensor after the hot-swap is complete:
1. Stop SNMP service in case of SNMPv2c [Stop Net-SNMP Agent in case of
SNMPv3].
2. Start SNMP service in case of SNMPv2c [Start Net-SNMP Agent in case of
SNMPv3].
3. Start the EmulexSensor service.