Emulex OneCommand Manager Application User Manual (P006979-01A Version 5.2, August 2011)

The OneCommand Manager User Manual Page 84
Pending Changes
• WWPN - Works in conjunction with the Change WWN button. Displays the World Wide Port
Name you assigned for the selected adapter port, but the system must be rebooted for these
changes to take effect and appear under the “Current” listing. See “Configuring Boot from SAN”
on page 159 for more information.
• WWNN - Works in conjunction with the Change WWN button. Displays the World Wide Node
Name you assigned for the selected adapter port, but the system must be rebooted for these
changes to take effect and appear under the “Current” listing. See “Configuring Boot from SAN”
on page 159 for more information.
Maintenance Tab Buttons (Not available in read-only mode.)
• Configure Boot - Click Configure Boot to configure boot from SAN. See “Configuring Boot from
SAN” on page 159 for more information. (Not available on VMware ESX servers being managed
through the CIM interface.)
• Change WWN - Click to change the selected adapter port's World Wide Node Name or World
Wide Port Name. See “Changing World Wide Name Configuration (FC/FCoE Ports Only)” on
page 132 for more information. (Not available on VMware ESX servers being managed through
the CIM interface.)
Viewing OneConnect Adapter Firmware Information
Unlike LightPulse adapters, OneConnect adapter firmware is maintained on an adapter-specific instead
of port-specific basis. Use this tab to download firmware and create diagnostic dumps for the selected
adapter.
To view OneConnect firmware information:
1. Select Host view.
2. Select a OneConnect adapter in the discovery-tree.
3. Select the Firmware tab.
Figure 46: OneConnect Firmware Tab
Note: iSCSI and NIC-Only adapters do not appear in Fabric view.