Emulex OneCommand Manager Command Line Interface User Manual (P006980-01A Version 5.2, August 2011)

OneCommand Manager Command Line Interface User Manual Page 5
In Linux with an Existing OneCommand Manager CLI Kit
Prerequisites
For existing systems the following must be installed before installing the OneCommand Manager CLI:
On LP21000 series adapters and OneConnect FCoE adapters:
• Linux driver version 8.2.0.x (For RHEL5.5and later and SLES10 SP3and later operating
systems)
• Linux driver version 8.3.5.x (For RHEL6 and later and SL11 SP1 and later operating systems)
On OneConnect iSCSI adapters:
• be2iscsi driver
On OneConnect NIC adapters:
• be2net driver
The be2net driver must also be installed if the adapter personality is iSCSI-NIC or FCoE-NIC.
Use the latest or matching driver from the Emulex website.
Procedures
You have two options when installing the OneCommand Manager CLI on a Linux system:
• Upgrade - preserve existing settings
• Clean install - overwrite existing settings
Upgrading
Follow these steps:
1. You must install the current core kit as detailed in installing the OneCommand Manager CLI “In
Linux” on page 4.
The .rpm file handles the configuration file upgrade.
Note: The core kit consists of 2 or 3 .rpm files for each supported architecture and
each supported version of Linux:
1. elxocmlibhbaapi-*.rpm (on 64bit platforms that support 32 bit apps, there will be 2
of these)
2. elxocmcore-*.rpm
Note: The OneCommand Manager core kit cannot be installed if a previous version of
the HBAnyware utility is installed.