Emulex OneCommand Manager Command Line Interface User Manual (P006980-01A Version 5.2, August 2011)

OneCommand Manager Command Line Interface User Manual Page 43
Dump Commands
The diagnostic dump feature enables you to create a “dump” file for a selected adapter. Dump files contain
information such as firmware version, driver version, and so on. This information is particularly useful when
troubleshooting an adapter. (Unavailable in read-only mode.)
Caution: Disruption of service can occur if a diagnostic dump is run during I/O activity.
DeleteDumpFiles
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd DeleteDumpFiles <WWPN|MAC>
Description: This command deletes all diagnostic dump files for the adapter.
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the CNA port
Dump
Supported by: Windows, Solaris, Linux and VMware ESX
Syntax:
hbacmd Dump <WWPN|MAC>
For LP adapters only:
hbacmd h=ipaddress[:port] m=cim [u=username] [p=password] [n=root/emulex] Dump
<WWPN|MAC>
Description: This command creates a diagnostic dump file in the hbacmd dump file directory.
Parameters:
WWPN - Adapter’s WWPN
MAC - MAC address of the CNA port
h - Host’s IP address.
m - cim
u - root
p - <password>
n - <namespace>
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 73.
Note: For managing ESX/ESXi hosts from a Windows client, add the m=cim option to
the command. The default CIM credentials must be set using the SetCimCred
command. See “SetCimCred” on page 73.