HP BladeSystem c-Class Enclosure Troubleshooting Guide

Enclosure troubleshooting 46
Step Onboard Administrator errors action and verification
Verification
Wait until the Insight Display indicates that the second or non-suspect Onboard
Administrator has completed power-on tests.
If the second or non-
suspect HP BladeSystem c3000 OA operates properly, then replace
the suspect Onboard Administrator and continue with step 9.
If the second or non-suspect OA has the same issue as the suspect OA, and the suspect OA
is OA1, then continue to the next step.
Step 7
Action
Reseat the OA tray:
1 Remove all Onboard Administrators from the OA tray.
2 Reseat the OA tray.
3 Install all Onboard Administrators in their original locations.
Verification
Wait until the Insight Display indicates that the Onboard Administrators have completed
power-on tests.
If the active Onboard Administrator operates properly, then the repair is complete.
If the active Onboard Administrator symptoms still exist, then replace the OA tray and
continue to step 9.
Step 8
Action
Contact an HP authorized service provider to complete the midplane assembly
replacement (on page 66).
Step 9
Action
Obtain the OA1 IP settings from the enclosure administrator.
Static OA1 IP settings:
1
Use the Insight Display Enclosure Settings information to change the OA1 IP address to
static.
2 Enter the following information recorded in the previous step:
-IP address
-Netmask
-Gateway
3 Record or tear off the replaced Onboard Administrator password from the label on the
OA tray.
DHCP OA IP settings:
1
Use the Insight Display Enclosure Settings information to change the OA1 IP address to
DHCP.
2 Record the following information:
-New OA1 IP address
-DNS name of the old Onboard Administrator from the label
-DNS name of the new Onboard Administrator from the label
3 Record or tear off the replaced Onboard Administrator password from the label on the
OA tray.