HP Scripting Toolkit 9.30 for Linux User Guide

HPONCFG return codes

MeaningValue

The script was sent successfully to the device.

The script could not be sent to the device. There is an error

in xml.

The Management processor is not present, or the driver is

not running.

The iLO flash is still in progress.

The script is unable to create an output file.

255

If the script itself fails, errors are reported in the log file created by HPONCFG.

HPONCFG command file contents

HPONCFG can be used to perform the following tasks:

• Obtain an entire configuration

• Obtain a specific configuration

• Set a configuration

Obtaining an entire configuration

HPONCFG can be used to obtain an entire configuration from iLO. In this case, the utility executes

from the command line without specification of an input file. The name of the output file is given

on the command line. For example:

hponcfg -w config.xml

In this example, the utility indicates that it obtained the data successfully and wrote it to the output

file as requested. The following is a typical example of the contents of the output file:

<MOD_DIR_CONFIG>

<DIR_AUTHENTICATION_ENABLED VALUE = "N"/>

<DIR_LOCAL_USER_ACCT VALUE = "Y"/>

<DIR_SERVER_ADDRESS VALUE = ""/>

<DIR_SERVER_PORT VALUE = "25"/>

<DIR_OBJECT_DN VALUE = " "/>

<DIR_OBJECT_PASSWORD VALUE = ""/>

<DIR_USER_CONTEXT_1 VALUE = ""/>

<DIR_USER_CONTEXT_2 VALUE = "_"/>

<DIR_USER_CONTEXT_3 VALUE = ""/>

</MOD_DIR_CONFIG>

<MOD_NETWORK_SETTINGS>

<SPEED_AUTOSELECT VALUE = "Y"/>

<NIC_SPEED VALUE = "100"/>

<FULL_DUPLEX VALUE = "Y"/>

<IP_ADDRESS VALUE = "11.222.333.444"/>

<SUBNET_MASK VALUE = "222.222.222.0"/>

<GATEWAY_IP_ADDRESS VALUE = "11.100.200.2"/>

Using HPONCFG 57