HP ProLiant BL680c G7 Server Blade Maintenance and Service Guide
Table Of Contents
- HP ProLiant BL680c G7 Server Blade Maintenance and Service Guide
- Abstract
- Notice
- Contents
- Customer self repair
- Illustrated parts catalog
- Removal and replacement procedures
- Required tools
- Safety considerations
- Server blade preparation
- Access panel (A-side)
- Access panel (B-side)
- Left DIMM baffle
- Right DIMM baffle
- DIMM (A-side)
- DIMM (B-side)
- Mezzanine connector cover (A-side)
- Mezzanine connector cover (B-side)
- Heatsink blank
- Mezzanine card (A-side)
- Mezzanine card (B-side)
- Hard drive blank
- Hard drive
- Front panel/hard drive cage assembly (A-side)
- Front panel/hard drive cage assembly (B-side)
- Battery-backed write cache procedures
- Interposer board
- Heatsink (A-side)
- Heatsink (B-side)
- Processor (A-side)
- Processor (B-side)
- System board (A-side)
- System board (B-side)
- System battery
- Server blade release lever
- Release button
- HP Trusted Platform Module
- Diagnostic tools
- Server component identification
- Cabling
- Specifications
- Acronyms and abbreviations
- Index
Removal and replacement procedures 31
2.
Prepare the server blade for installation.
3. Install the server blade.
Access panel (A-side)
To remove the component:
1. Power down the server blade (on page 28).
2. Remove the server blade (on page 29).
3. Press the access panel release button, and then slide the access panel to the rear.
4. Remove the access panel.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.