HP ProLiant BL680c G7 Server Blade Maintenance and Service Guide
Table Of Contents
- HP ProLiant BL680c G7 Server Blade Maintenance and Service Guide
- Abstract
- Notice
- Contents
- Customer self repair
- Illustrated parts catalog
- Removal and replacement procedures
- Required tools
- Safety considerations
- Server blade preparation
- Access panel (A-side)
- Access panel (B-side)
- Left DIMM baffle
- Right DIMM baffle
- DIMM (A-side)
- DIMM (B-side)
- Mezzanine connector cover (A-side)
- Mezzanine connector cover (B-side)
- Heatsink blank
- Mezzanine card (A-side)
- Mezzanine card (B-side)
- Hard drive blank
- Hard drive
- Front panel/hard drive cage assembly (A-side)
- Front panel/hard drive cage assembly (B-side)
- Battery-backed write cache procedures
- Interposer board
- Heatsink (A-side)
- Heatsink (B-side)
- Processor (A-side)
- Processor (B-side)
- System board (A-side)
- System board (B-side)
- System battery
- Server blade release lever
- Release button
- HP Trusted Platform Module
- Diagnostic tools
- Server component identification
- Cabling
- Specifications
- Acronyms and abbreviations
- Index
Removal and replacement procedures 43
4.
Disconnect the signal cable and the power cable from the SAS backplane.
5. Loosen the thumbscrews.
6. Remove the screws from the side of the server blade.
7. Remove the front panel/hard drive cage assembly.
To replace the component, reverse the removal procedure.
Front panel/hard drive cage assembly (B-side)
To remove the component:
1. Power down the server blade (on page 28).
2. Remove the server blade (on page 29).
3. Remove the access panel (B-side) ("Access panel (B-side)" on page 32).
4. Disconnect the signal cable and power cable from the SAS backplane.
5. Loosen the thumbscrews.
6. Remove the screws from the side of the server blade.