Important Information HP Smart Array P-Series Battery Pack Installation for the HP Smart Array E500 Controller in HP ProLiant DL140 and DL145 Generation 3 Servers

ManualsBrandsHP ManualsServerHP ProLiant DL145 G3 Server

Important Information

HP Smart Array P-Series

Battery Pack Installation for

the HP Smart Array E500

Controller in HP ProLiant

DL140 and DL145

Generation 3 Servers

Overview

To prevent damage to the server or the battery pack, the

battery pack must be secured to the chassis.

Obtain the most current information from the following HP

websites:

• HP ProLiant DL140 Generation 3 Server product website

(http://www.hp.com/servers/proliantdl140

• HP ProLiant DL145 Generation 3 Server product website

(http://www.hp.com/servers/proliantdl145

• HP ProLiant Smart Array controller product website

(http://www.hp.com/go/serial

Installing a cache module

battery pack

WARNING: There is a risk of explosion, fire, or

personal injury if a battery pack is mishandled. To

reduce this risk:

• Do not attempt to recharge the batteries if they

are disconnected from the controller.

• Do not expose the battery pack to water, or to

temperatures higher than 60°C (140°F).

• Do not abuse, disassemble, crush, or puncture the

battery pack.

• Do not short the external contacts.

• Replace the battery pack only with the

designated HP spare.

• Battery disposal should comply with local

regulations.

IMPORTANT: When installing a cache module

battery pack, the HBA must be installed in the full-

length PCI slot.

1. Power down the server.

2. Remove the server from the rack, if necessary.

3. Remove the access panel.

4. Remove the HBA and riser board assembly from the

server.

The information contained herein is subject to change without notice. The only

warranties for HP products and services are set forth in the express warranty

statements accompanying such products and services. Nothing herein should

be construed as constituting an additional warranty. HP shall not be liable for

technical or editorial errors or omissions contained herein.

Part Number 447951-001

February 2007 (First Edition)

Summary of content (2 pages)

PAGE 1
Important Information HP Smart Array P-Series Battery Pack Installation for the HP Smart Array E500 Controller in HP ProLiant DL140 and DL145 Generation 3 Servers Overview To prevent damage to the server or the battery pack, the battery pack must be secured to the chassis. Obtain the most current information from the following HP websites: • HP ProLiant DL140 Generation 3 Server product website (http://www.hp.com/servers/proliantdl140).
PAGE 2
5. Connect the battery cable (supplied in the battery pack kit) to the battery pack. 6. Remove the protective strip from the adhesive-backed hook-and-loop tape on the battery pack. IMPORTANT: To maintain proper clearances, install the battery pack in the specific location shown in the illustration. 7. 8. Install the battery pack: o HP ProLiant DL140 Generation 3 Server o HP ProLiant DL145 Generation 3 Server Install the HBA and riser board assembly in the server. 9. Install the access panel.