HP ProLiant DL170e G6 Server Installation Sheet

IMPORTANT: Be sure the processor remains inside the
processor installation tool.
2. If the processor has separated from the installation tool,
carefully re-insert the processor in the tool. Handle the
processor by the edges only, and do not touch the bottom of
the processor, especially the contact area.
Figure 17 Reinserting the Processor
3. Align the processor installation tool with the socket, and then
install the processor. THE PINS ON THE SYSTEM BOARD ARE
VERY FRAGILE AND EASILY DAMAGED.
Figure 18 Installing the Processor
CAUTION: THE PINS ON THE SYSTEM BOARD ARE VERY
FRAGILE AND EASILY DAMAGED. To avoid damage to
the system board:
• Never install or remove a processor without using the
processor installation tool.
• Do not touch the processor socket contacts.
• Do not tilt or slide the processor when lowering the
processor into the socket.
4. Press the tabs on the processor installation tool to separate it
from the processor, and then remove the tool.
Figure 19 Removing the Tool
5. Close the processor socket retaining bracket and the processor
locking lever. The processor socket cover is automatically
ejected. Remove the cover.
Figure 20 Closing the Bracket and Lever,and Removing Cover
CAUTION: Be sure to close the processor socket
retaining bracket before closing the processor locking
lever. The lever should close without resistance. Forcing
the lever closed can damage the processor and socket,
requiring system board replacement.
For processor removal, reverse the above installation procedures,
using the processor tool to remove the processor.
To install the heat sink: