Manualshelf

HP ProLiant DL180 Generation 5 Server Software Configuration Guide

ManualsBrandsHP ManualsServerHP ProLiant DL180 G5 Server
37383940414243444546
43
Server management
Pre- and post-installation procedures
Pre-installation procedures
WARNING: Failure to properly turn off the server before you open the server or before you start
removing or installing hardware components may cause serious damage as well as bodily harm.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the chassis and any
installed hardware components to cool before touching them.
CAUTION: Follow the ESD precautions listed in Chapter 2 of the HP ProLiant DL180 Generation 5
Server Maintenance and Service Guide when handling any hardware component.
1. Turn off the server and all the peripherals connected to it.
2. Disconnect the AC power cord from the power supply cable located on the server rear panel to turn
off the service processor and reduce the risk of electrical shock.
3. Remove the top cover from the chassis.
4. Place the top cover in a safe place for reinstallation later.
Post-installation procedures
1. Be sure all components are installed according to the described step-by-step instructions.
2. Check to make sure you have not left loose tools or parts inside the server.
3. Reinstall any expansion boards, riser board assemblies, peripherals, board covers, brackets, and
system cables that you have removed.
4. Reinstall the top cover:
a. Place the cover on the chassis approximately 1.25 cm (0.5 in) toward the rear of the unit, then
slide the cover forward into place.
b. Tighten the captive screw on the rear panel.
5. Connect all external cables and the AC power cord to the system.
Route the cables properly through the available cable management arrangement.
6. Press the power button on the front panel to turn on the server.
Configuring the BMC
The server includes a BMC for systems management, which you can access through a 10/100 Mbps LAN
port for IPMI management. To access the BMC through this LAN port, you must configure the IP address.
You can configure the settings for the BMC by using either the Setup Utility or another system (such as a