HP Smart Update Manager 5.3.5 Release Notes (Ed. 3)

HP SUM does not update iLO 3 from version 1.2x to 1.5x
HP SUM doe snot update the iLO directly from 1.2x to 1.5x.
Suggested action: Update the NIC instead of the ilO. The NIC will install the proper driver for the iLO.
HP SUM cannot update some HDD targets
HP SUM does not support updating HDD targets that are attached to an HP Smart Array controller
running in Zero Memory mode or an HP ProLiant host bus adapter.
Suggested action: Perform the updates in offline mode.
HP SUM select VMware updates instead of Linux updates
For some components, HP SUM does not allow you to select the Linux update, it select the VMware
update automatically.
Suggested action: Exit HP SUM, remove the VMware component from the repository, and then restart
HP SUM.
HP SUM cannot start a session on a remote server
If HP SUM cannot start a session on a remote server, HP SUM is missing some dependencies.
Suggested action: Exit HP SUM, download the latest HP SUM RPM from the HP SDR. For more
information on installing the RPM, see “Installation instructions” (page 12).
You cannot update an HBA firmware online
HP SUM requires a minimum version of HBA firmware before you can update the HBA firmware in
online mode.
Suggested action: HP SUM supports updating from firmware version 4.1.360.15 in online mode.
Update in offline mode until you reach the minimum version for online support.
HP SUM displays a Failed to transform hardware discovery results error
on the Select Targets screen
If HP SUM displays a Failed to transform hardware discovery results error on the
Select Targets screen and cannot complete discovery of a target, the discovery.xml file might
contain non ASCII characters.
Suggested action: Verify that the discovery.xml file does not contain non-ASCII characters.
After discovery, HP SUM does not verify there is enough space to update FC switches
HP SUM does not verify that there is enough space on an FC switch to apply a firmware update.
Suggested action: Verify that there is enough space on the FC switch before running HP SUM.
HP SUM is unable to configure components on Windows Hyper-V
HP SUM will not run on Windows Hyper-V. Components must be configured from a different system
and can be deployed remotely to the Hyper-V server. Hyper-V is only supported as a target server,
not a deployment server.
Suggestion action: No action. This is expected behavior.
If you deselect a target during the discovery process, HP SUM will continue to discover the
target
On the Select Target screen, if you deselect a target while HP SUM is attempting to discover it, HP
SUM will continue the discovery process. You cannot proceed until HP SUM finishes the discovery
process.
Suggestion action: No action. This is expected behavior.
14 Issues and suggested actions