HP ProLiant DL320e Gen8 v2 Server Maintenance and Service Guide

Removal and replacement procedures 60
7.
Remove the internal USB connector.
To replace the component, reverse the removal procedure.
Integrated power supply rear cover
To remove the component:
1. Power down the server (on page 28).
2. Remove the power from the server:
a. Disconnect the power cord from the power source.
b. Disconnect the power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 29).
o Remove the server from the rack (on page 30).
4. Remove the access panel ("Access panel" on page 35).