Installation Manual

• Use DHCPv4 Supplied DNS Servers—Specifies whether iLO uses the DHCP server-supplied
DNS server list. If not, enter the DNS server addresses in the Primary DNS Server,
Secondary DNS Server, and Tertiary DNS Server boxes.
• Use DHCPv4 Supplied Time Settings—Specifies whether iLO uses the DHCPv4-supplied
NTP service locations.
• Use DHCPv4 Supplied WINS Servers—Specifies whether iLO uses the DHCP
server-supplied WINS server list. If not, enter the WINS server addresses in the Primary
WINS Server and Secondary WINS Server boxes.
General IPv4 settings
• IPv4 Address—The iLO IP address. If DHCP is used, the iLO IP address is supplied
automatically. If DHCP is not used, enter a static IP address.
• Subnet Mask—The subnet mask of the iLO IP network. If DHCP is used, the subnet mask
is supplied automatically. If DHCP is not used, enter a subnet mask for the network.
• Gateway IPv4 Address—The iLO gateway IP address. If DHCP is used, the iLO gateway
IP address is supplied automatically. If DHCP is not used, enter the iLO gateway IP address.
• Static Route #1, Static Route #2, and Static Route #3—The iLO static route destination,
mask, and gateway addresses. If Use DHCPv4 Supplied Static Routes is used, these
values are supplied automatically. If not, enter the static route values.
DNS server settings
• Primary DNS Server—If Use DHCPv4 Supplied DNS Servers is enabled, this value is
supplied automatically. If not, enter the Primary DNS Server address.
• Secondary DNS Server—If Use DHCPv4 Supplied DNS Servers is enabled, this value is
supplied automatically. If not, enter the Secondary DNS Server address.
• Tertiary DNS Server—If Use DHCPv4 Supplied DNS Servers is enabled, this value is
supplied automatically. If not, enter the Tertiary DNS Server address.
• Enable DDNS Server Registration—Select or clear this check box to specify whether iLO
registers its IPv4 address and name with a DNS server.
WINS server settings
• Primary WINS Server—If Use DHCPv4 Supplied WINS Servers is enabled, this value is
supplied automatically. If not, enter the Primary WINS Server address.
• Secondary WINS Server—If Use DHCPv4 Supplied WINS Servers is enabled, this value
is supplied automatically. If not, enter the Secondary WINS Server address.
• Enable WINS Server Registration—Specifies whether iLO registers its name with a WINS
server.
Ping Gateway on Startup setting
This setting causes iLO to send four ICMP echo request packets to the gateway when the iLO
processor initializes. This activity ensures that the ARP cache entry for iLO is up-to-date on the
router responsible for routing packets to and from iLO.
Configuring IPv6 settings
Use the iLO Dedicated Network Port IPv6 Settings page to configure the iLO IPv6 settings.
Configuring IPv6 settings 103