Installation Manual

Table 3 SNMP traps (continued)
DescriptionSNMP trap name
Communication with Insight Remote Support or Insight
Online has failed.
cpqSm2IrsCommFailure 9020
Generic trap. Verifies that the SNMP configuration, client
SNMP console, and network are operating correctly. You
cpqHo2GenericTrap 11003
can use the iLO web interface to generate this alert to
verify receipt of the alert on the SNMP console.
A power threshold has been exceeded.cpqHo2PowerThresholdTrap 11018
A change in the health status of the server has occurred.cpqHoMibHealthStatusArrayChangeTrap 11020
AMS detected a change in the status of an SAS or SATA
physical drive.
cpqSasPhyDrvStatusChange 5022
AMS detected a change in the status of an ATA disk drive.cpqIdeAtaDiskStatusChange 14004
AMS detected a change in the status of a Fibre Channel
host controller.
cpqFca3HostCntlrStatusChange 16028
Connectivity was restored to a logical network adapter.cpqNic3ConnectivityRestored 18011
The status of a logical network adapter changed to Failed.cpqNic3ConnectivityLost 18012
AMS detected that a previously failed physical adapter in
a connected logical adapter group returned to the OK
status.
cpqNic3RedundancyIncreased 18013
AMS detected that a physical adapter in a logical adapter
group changed to Failed status, but at least one physical
adapter remains in OK status.
cpqNic3RedundancyReduced 18014
For more information about these SNMP traps, see the following files in the Insight Management
MIB update kit for HPE SIM:
• cpqida.mib
• cpqhost.mib
• cpqhlth.mib
• cpqsm2.mib
• cpqide.mib
• cpqscsi.mib
• cpqnic.mib
• cpqstsys.mib
• cpqstdeq.mib
Configuring Insight Management integration
Prerequisites
Configure iLO Settings privilege
Configuring the Insight Management settings
1. Navigate to the Administration→Management page.
2. On the SNMP Settings tab, scroll to the Insight Management Integration section.
3. Configure the HPE SMH FQDN/IP Address.
124 Configuring iLO management settings