Installation Manual

4. From the System Utilities screen, select System Configuration→iLO 4 Configuration
Utility→Setting Options, and press Enter.
5. View or update the access settings.
6. Press F10.
7. Press Esc until the main menu is displayed.
8. Select Exit and Resume Boot in the main menu, and then press Enter.
9. When prompted to confirm the request, press Enter to exit the utility and resume the boot
process.
More information
Access options
Viewing information about iLO by using the iLO 4 Configuration Utility
1. Optional: If you access the server remotely, start an iLO remote console session.
2. Restart or power on the server.
3. Press F9 in the server POST screen to start the UEFI System Utilities.
4. From the System Utilities screen, select System Configuration→iLO 4 Configuration
Utility→About, and press Enter.
5. View information about iLO components.
6. Press Esc until the main menu is displayed.
7. Select Exit and Resume Boot in the main menu, and then press Enter.
8. When prompted to confirm the request, press Enter to exit the utility and resume the boot
process.
About
Use this menu to view information about the following iLO components.
• Firmware Date—The iLO firmware revision date.
• Firmware Version—The iLO firmware version.
• iLO CPLD Version—The iLO complex programmable logic device version.
• Host CPLD Version—The server complex programmable logic device version.
• Serial Number—The iLO serial number.
• RBSU Date—The iLO 4 Configuration Utility revision date.
• PCI BUS—The PCI bus to which the iLO processer is attached.
• Device—The device number assigned to iLO in the PCI bus.
Viewing information about iLO by using the iLO 4 Configuration Utility 145