Installation Manual

• LRDIMM
• NVDIMM
• R-NVDIMM
Viewing network information
1. Navigate to the Information→System Information page, and then click the Network tab.
2. Optional: To expand or collapse the information on this page, click Expand All or Collapse
All, respectively.
If the server is powered off, the health status information on this page is current as of the last
power off. Health information is updated only when the server is powered on and POST is
complete.
To view a full set of data on this page, ensure that AMS is installed and running. The server IP
address, add in network adapters, and the server NIC status are displayed only if AMS is installed
and running on the server.
The information on this page is updated when you log in to iLO. To refresh the data, log out of
iLO, and then log back in.
Physical Network Adapters
Integrated and add-in NICs and Fibre Channel adapters
This section displays the following information about the integrated and add-in NICs and Fibre
Channel adapters in the server:
• Adapter number—The adapter number, for example, Adapter 1 or Adapter 2.
• Device Type—The device type is one of the following:
iLO—This device type is assigned to the iLO Dedicated Network Port or Shared Network
Port.
◦
◦ <NIC type>—This device type indicates NIC or LAN adapter components embedded
in the server or added after manufacturing. Because system NICs are directly available
Viewing network information 169