Installation Manual

Boot progress and boot targets
The following information about the boot progress and boot targets is displayed when DCI
connectivity is available:
• Port—The configured virtual port number.
• Boot Progress—The current boot status.
• Boot Targets
WWPN—The world wide port name.◦
◦ LUN ID—The logical unit number ID.
Logical Network Adapters
This section displays the following information about network adapters that use NIC teaming to
combine two or more ports into a single logical network connection:
• Adapter name—The name of the configured link between the physical ports that form the
logical network adapter.
• MAC Address—The logical network adapter MAC address.
• IP Address—The logical network adapter IP address.
• Status—The logical network adapter status.
The following information is displayed for the ports that form each logical network adapter:
• Members—A sequential number assigned to each port that forms the logical network adapter.
• MAC Address—The MAC address of the physical adapter port.
• Status—The status of the physical adapter port.
Viewing the device inventory
Navigate to the Information→System Information page, and then click the Device Inventory
tab.
The Device Inventory page displays information about devices installed on the system board.
Some examples of the devices listed on this page include installed adapters, PCI devices, SATA
controllers, and Smart Storage batteries.
If the server is powered off, the health status information on this page is current as of the last
power on. Health information is updated only when the server is powered on and POST is
complete.
Viewing the device inventory 171