Installation Manual

top-level controller status changes to Major Warning or Degraded, depending on the failure
type. If the controller hardware has a Failed status, the top-level controller status is Failed.
• Controller Status—Controller hardware status (OK or Failed)
• Serial Number
• Model
• Firmware Version
• Controller Type
• Cache Module Status
• Cache Module Serial Number
• Cache Module Memory
• Encryption Status—Indicates whether encryption is enabled in the controller.
The following values are possible:
◦ Enabled
◦ Not Enabled
◦ Enabled—Local Mode—This value is displayed when you do not use a remote key
management server.
• Encryption ASIC Status—Indicates whether the ASIC encryption self tests for the controller
passed or failed. A failed status indicates that the controller is not encrypted.
• Encryption Critical Security Parameter NVRAM Status—Indicates whether the controller
successfully detected the critical security parameter NVRAM. A failed status means that the
controller is not encrypted.
The encryption settings for a Smart Array controller can be configured by using the Smart Storage
Administrator software.
Drive Enclosures
This section provides the following information about the drive enclosures attached to a Smart
Array controller.
• Enclosure port and box numbers
• Status
• Drive Bays—The number of drive bays
• Serial Number
• Model
• Firmware Version
Some enclosures do not have all of the listed properties, and some storage configurations do
not have drive enclosures.
Viewing storage information 175