Installation Manual

If this check box is not selected, the disk image will remain connected until it is ejected
manually, and the servers will boot to it on all subsequent server resets, if the system boot
options are configured accordingly.
If a server in the group is in POST when you use the Boot on Next Reset check box, an
error occurs because you cannot modify the server boot order during POST. Wait for POST
to finish, and then try again.
5. Click Insert Media.
iLO displays the command results.
Viewing scripted media status for groups
Navigate to the iLO Federation→Group Virtual Media page.
Scripted media details
When scripted media is connected to the systems in an iLO Federation group, the following
details are listed in the Virtual Floppy Status section and Virtual CD/DVD-ROM Status section:
• Media Inserted—The Virtual Media type that is connected. Scripted Media is displayed
when scripted media is connected.
• Connected—Indicates whether a Virtual Media device is connected.
• Image URL—The URL that points to the connected scripted media.
The Virtual Floppy Status and Virtual CD/DVD-ROM Status sections are displayed only when
media is connected.
Ejecting a scripted media device
Prerequisites
• An iLO license that supports this feature is installed. For more information, see the following
website: http://www.hpe.com/info/ilo/licensing.
• Each member of the selected iLO Federation group has granted the Virtual Media privilege
to the group.
Ejecting a scripted media device
1. Navigate to the iLO Federation→Group Virtual Media page.
204 Using iLO Federation