Installation Manual

Viewing group power capping information
Prerequisites
An iLO license that supports this feature is installed. For more information, see the following
website: http://www.hpe.com/info/ilo/licensing.
Viewing group power capping information
1. Navigate to the iLO Federation→Group Power Settings page.
2. Select a group from the Selected Group menu.
3. Optional: When values are displayed in watts, click Show values in BTU/hr to change the
display to BTU/hr. When values are displayed in BTU/hr, click Show values in Watts to
change the display to watts.
Power capping details
• HPE Automatic Group Power Capping Settings—This section shows the following details:
Measured Power Values—The maximum available power, peak observed power, and
minimum observed power.
◦
◦ Power Cap Value—The power cap value, if one is configured.
• Current State—This section includes the following details:
Present Power Reading—The current power reading for the selected group.◦
◦ Present Power Cap—The total amount of power allocated to the selected group. This
value is 0 if a power cap is not configured.
• Group Power Allocations for this system—The group power caps that affect the local
iLO system, and the amount of power allocated to the local iLO system by each group power
cap. If a power cap is not configured, the allocated power value is 0.
Configuring group power capping 209