Installation Manual

• USB Storage Device
• Hard Disk Drive
• Network Device <number>, where the server Ethernet card and additional
NIC/FlexibleLOM cards are Network Device 1, Network Device 2, Network Device 3,
and so on.
In UEFI mode, select an option from the list of available boot devices.
3. Click Apply.
iLO confirms that the boot order was updated successfully.
Changing the one-time boot status
Use the one-time boot status feature to set the type of media to boot on the next server reset,
without changing the predefined boot order. The procedure to use depends on whether the server
uses Legacy BIOS mode or UEFI mode.
Prerequisites
Configure iLO Settings privilege
Changing the one-time boot status in Legacy BIOS mode
1. Navigate to the Virtual Media→Boot Order page.
2. Select an option from the Select One-Time Boot Option list.
The following options are available:
• No One-Time Boot
• CD/DVD Drive
• Floppy Drive (ProLiant Gen8 servers only)
• USB Storage Device
• Hard Disk Drive
• Network Device <number>, where the server Ethernet card is Network Device 1, and
additional NIC/FlexibleLOM cards are Network Device 2, Network Device 3, and so on.
• Intelligent Provisioning
• Embedded UEFI Shell—When you select this option, the server boots to an embedded
shell environment that is separate from the UEFI System Utilities.
3. Click Apply.
iLO confirms that the one-time boot option was updated successfully.
The Current One-Time Boot Option value is updated to show the selection.
Virtual Media Boot Order 243