Installation Manual

Changing the one-time boot status in UEFI mode
1. Navigate to the Virtual Media→Boot Order page.
2. Select an option from the Select One-Time Boot Option list.
The following options are available:
• No One-Time Boot
• CD/DVD Drive
• Floppy Drive (ProLiant Gen8 servers only)
• USB Storage Device
• Hard Disk Drive
• Network Device <number>, where the server Ethernet card is Network Device 1, and
additional NIC/FlexibleLOM cards are Network Device 2, Network Device 3, and so on.
• Intelligent Provisioning
• UEFI Target—When you select this option, you can select from the list of available boot
devices in the Select UEFI Target Option list.
• Embedded UEFI Shell—When you select this option, the server boots to an embedded
shell environment that is separate from the UEFI System Utilities.
3. If you selected UEFI Target in the Select One-Time Boot Option list, select a boot device
from the Select UEFI Target Option list. For example, you might have a hard drive with two
bootable partitions, and you can use this option to select the bootable partition to use on the
next server reset.
4. Click Apply.
iLO confirms that the one-time boot option was updated successfully.
The Current One-Time Boot Option value is updated to show the selection.
Using the additional options
The Additional Options section on the Boot Order page provides buttons for resetting the
server and booting to the system setup utilities.
Navigate to the Virtual Media→Boot Order page.
• Depending on whether your system supports the legacy system RBSU or the UEFI System
Utilities, click Boot to System RBSU or Boot to System Setup Utilities to load the
ROM-based setup utility on the next server reset. The Virtual Media and Configure iLO
Settings privileges are required to use this feature.
• Click Server Reset to reboot the server. If a one-time boot option is specified, this setting
takes precedence over the Server Boot Order value. The Virtual Power and Reset privilege
is required to use this feature.
244 Using iLO Virtual Media