Installation Manual

2. Restart or power on the server.
3. Press F8 in the server POST screen.
The iLO RBSU starts.
4. Disable DHCP:
a. From the iLO RBSU screen, select Network→DNS/DHCP, and then press Enter.
b. Select DHCP Enable.
c. To set DHCP Enable to OFF, press the spacebar, and then press F10 to save the
changes.
5. Enter the network settings:
a. From the iLO RBSU screen, select Network→NIC and TCP/IP, and then press Enter.
b. Enter the appropriate information in the IP Address, Subnet Mask, and Gateway IP
Address fields.
c. To save the changes, press F10.
6. Select File→Exit.
The changes take effect when you exit iLO RBSU.
Configuring a static IP address (iLO 4 Configuration Utility)
1. Optional: If you access the server remotely, start an iLO remote console session.
2. Restart or power on the server.
3. Press F9 in the server POST screen.
The UEFI System Utilities start.
4. From the System Configuration screen, use the up or down arrow keys and the Enter key
to navigate to the System Configuration→iLO 4 Configuration Utility→Network Options
screen.
5. Disable DHCP:
a. Select DHCP Enable, and then press Enter.
b. Select OFF, and then press Enter.
6. Enter an IP address, subnet mask, and gateway IP address:
a. Select IP Address, and then press Enter.
b. Type the IP address, and then press Enter.
c. Select Subnet Mask, and then press Enter.
d. Type the subnet mask address, and then press Enter.
e. Select Gateway IP Address, and then press Enter.
f. Type the gateway IP address, and then press Enter.
7. To save the changes, press F10.
The iLO 4 Configuration Utility prompts you to confirm that you want to save all pending
configuration changes.
8. To save and exit, press Y.
The iLO 4 Configuration Utility notifies you that iLO must be reset in order for the changes
to take effect.
9. Press Enter.
iLO resets, and the iLO session is automatically ended. You can reconnect in approximately
30 seconds.
28 Setting up iLO