Installation Manual

4. Enter an iLO login name and password, and then click Find.
If you click Next, click Back, or exit the utility during discovery, operations on the current
network address are completed, but operations on subsequent network addresses are
canceled.
When the search is complete, the management processors are listed and the Find button
changes to Verify.
More information
HPLOMIG management processor search criteria
HPLOMIG management processor import list requirements
HPLOMIG management processor search criteria
You can search for management processors by using DNS names, IP addresses, or IP address
wildcards.
The following rules apply when you enter values in the Addresses box:
• DNS names, IP addresses, and IP address wildcards must be delimited either with semicolons
or commas, not both.
• The IP address wildcard uses the asterisk (*) character in the third and fourth octet fields.
For example, IP address 16.100.*.* is valid, and IP address 16.*.*.* is invalid.
• Ranges can be specified by using a hyphen. For example, 192.168.0.2-10 is a valid
range. A hyphen is supported only in the rightmost octet.
• After you click Find, HPLOMIG begins pinging and connecting to port 443 (the default SSL
port) to determine whether the target network address is a management processor. If the
device does not respond to the ping or connect appropriately on port 443, the utility
determines that it is not a management processor.
Configuring directory authentication with HPLOMIG 305