Installation Manual

Viewing the Preboot Health Summary
• Use one of the following methods to access the Preboot Health Summary:
• Press the UID button on the server.
CAUTION: To use this feature, press and release the UID button. Holding it down at
any time for more than 5 seconds initiates a graceful iLO reboot or a hardware iLO
reboot. Data loss or NVRAM corruption might occur during a hardware iLO reboot.
• Log in to the iLO web interface, and change the UID state to UID ON. To change the
UID state, click the UID icon at the bottom right corner of any iLO web interface window.
• Connect the SUV cable to the SUV connector.
The Preboot Health Summary screen is displayed on the server monitor. This screen remains
until the server is powered on, the UID state is changed to UID OFF, an SUV connector is
removed, or an iLO reboot completes.
Preboot Health Summary details
The following information is displayed when you view the Preboot Health Summary:
• Server model number
• Server serial number
• Product ID
• iLO IP address (IPv4 and IPv6)—This value is displayed only if Show iLO IP during POST
is set to Enabled on the Administration→Access Settings page in iLO.
For more information, see “iLO access settings” (page 61).
• iLO Hostname
• iLO firmware version
• ProLiant System ROM version
• ProLiant System ROM – Backup version
• iLO CPLD version
• System CPLD version
Using the ProLiant Preboot Health Summary 321