Installation Manual

Action
To remove the server name after the redeployment of a server, do one of the following:
• To update the server name, load the Insight Management Agents.
• Set iLO to the factory default settings by using iLO RBSU or the iLO 4 Configuration Utility.
CAUTION: This procedure clears all iLO configuration information, not just the Server
Name.
For more information, see “Resetting iLO to the factory default settings (iLO RBSU)” (page
197) and “Resetting iLO to the factory default settings (iLO 4 Configuration Utility)” (page 197).
• Change the server name on the Administration→Access Settings→Access Options
page in the iLO web interface.
AMS is installed but unavailable in iLO
Symptom
AMS is installed on a server, but it is listed as Not available in the iLO web interface
Solution 1
Action
Verify that AMS is installed.
For more information, see “Verifying the AMS installation” (page 114).
Solution 2
Action
Restart AMS.
For more information, see “Restarting AMS” (page 115).
Solution 3
Action
Reset iLO.
For more information, see “iLO diagnostics” (page 193).
358 Troubleshooting