Installation Manual

7. To save the configuration, click Create Group.
The group creation process takes a few minutes. The group will be fully populated within
the amount of time configured for the Multicast Announcement Interval.
More information
Selected Group list filters
Adding iLO Federation group memberships (local iLO system)
iLO Federation group privileges
Access options
Servers affected by a group membership change
The Affected Systems section on the Group Configuration page provides the following details
about the servers affected when you make a group membership change:
• Server Name—The server name defined by the host operating system.
• Server Power—The server power state (ON or OFF).
• UID Indicator—The state of the UID LED. The UID LED helps you identify and locate a
server, especially in high-density rack environments. The possible states are UID ON, UID
OFF, and UID BLINK.
• iLO Hostname—The fully qualified network name assigned to the iLO subsystem. To open
the iLO web interface for the server, click the link in the iLO Hostname column.
• IP Address—The network IP address of the iLO subsystem. To open the iLO web interface
for the server, click the link in the IP Address column.
Click Next or Previous (if available) to view more servers in the list.
More information
Exporting iLO Federation information to a CSV file
Configuring Enclosure iLO Federation Support
If you want to use the iLO Federation features with server blades in a BladeSystem c-Class
enclosure, the Enclosure iLO Federation Support setting must be enabled in the Onboard
Administrator software. This setting is required to allow peer-to-peer communication between
the server blades in an enclosure. Enclosure iLO Federation Support is enabled by default.
Prerequisites
Onboard Administrator 4.11 or later is installed.
Configuring Enclosure iLO Federation Support
1. Log in to the Onboard Administrator web interface (https://<OA hostname or IP address>).
2. Navigate to the Enclosure Information→Enclosure Settings→Network Access page,
and then click the Protocols tab.
Configuring Enclosure iLO Federation Support 59