Installation Manual

You can configure the following settings in the Service section on the Access Settings page.
• Secure Shell (SSH) Access—Allows you to enable or disable the SSH feature.
SSH provides encrypted access to the iLO CLP. The default value is Enabled.
• Secure Shell (SSH) Port—The default value is 22.
• Remote Console Port—The default value is 17990.
• Web Server Non-SSL Port (HTTP)—The default value is 80.
• Web Server SSL Port (HTTPS)—The default value is 443.
• Virtual Media Port—The default value is 17988.
• SNMP Access—Specifies whether iLO responds to external SNMP requests. The default
value is Enabled.
If you set SNMP Access to Disabled, iLO continues to operate, and the information displayed
in the iLO web interface is updated. In this state, no alerts are generated and SNMP access
is not permitted. When SNMP Access is set to Disabled, most of the boxes on the
Administration→Management→SNMP Settings page are unavailable and will not accept
input.
• SNMP Port—The industry-standard (default) SNMP port is 161 for SNMP access.
If you customize the SNMP Port value, some SNMP clients might not work correctly with
iLO unless those clients support the use of a nonstandard SNMP port.
• SNMP Trap Port—The industry-standard (default) SNMP trap port is 162 for SNMP alerts
(or traps).
If you customize the SNMP Trap Port, some SNMP monitoring applications (like HPE SIM)
might not work correctly with iLO unless those applications support the use of a nonstandard
SNMP trap port.
To use SNMP v3 with HPE SIM 7.2 or later, change the SNMP Trap Port value to 50005.
• IPMI/DCMI over LAN Access—Allows you to send industry-standard IPMI and DCMI
commands over the LAN. The default value is Enabled.
If you set this value to Disabled, iLO disables IPMI/DCMI over the LAN. Server-side
IPMI/DCMI applications are still functional when this option is disabled.
If you set this value to Enabled, iLO allows you to use a client-side application to send
IPMI/DCMI commands over the LAN.
• IPMI/DCMI over LAN Port—Sets the IPMI/DCMI port number. The default value is 623.
Configuring iLO access options
Prerequisites
Configure iLO Settings privilege
Configuring access options
1. Navigate to the Administration→Access Settings page.
2. Click the Access Settings tab.
3. Update the access options as needed.
4. Click Apply.
If you set the iLO Functionality setting to Disabled, clicking Apply ends your browser
connection and restarts iLO.
It might take several minutes before you can re-establish a connection.
62 Configuring iLO access settings