Installation Manual

More information
Configuring NIC and TCP/IP settings (iLO RBSU)
Configuring the NIC settings
IPv4 Summary details
• DHCPv4 Status—Indicates whether DHCP is enabled for IPv4.
• Address—The IPv4 address currently in use. If the value is 0.0.0.0, the IPv4 address is
not configured.
• Subnet Mask—The subnet mask of the IPv4 address currently in use. If the value is
0.0.0.0, no address is configured.
• Default Gateway—The default gateway address in use for the IPv4 protocol. If the value is
0.0.0.0, the gateway is not configured.
More information
Configuring IPv4 settings
IPv6 Summary details
This section is displayed only for the iLO Dedicated Network Port.
• DHCPv6 Status—Indicates whether DHCP is enabled for IPv6. The following values are
possible:
◦ Enabled—Stateless and Stateful DHCPv6 are enabled.
◦ Enabled (Stateless)—Only Stateless DHCPv6 is enabled.
◦ Disabled—DHCPv6 is disabled.
• IPv6 Stateless Address Auto-Configuration (SLAAC)—Indicates whether SLAAC is
enabled for IPv6. When SLAAC is disabled, the SLAAC link-local address for iLO is still
configured because it is required.
• Address list—This table shows the currently configured IPv6 addresses for iLO. It provides
the following information:
◦ Source—Indicates whether the address is a static or SLAAC address.
◦ IPv6—The IPv6 address.
Viewing the network configuration summary 97