HP ProLiant DL360p Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 49
Rack bezel
Remove the component as indicated.
To replace the component, reverse the removal procedure.
Air baffle
To remove the component:
1. Power down the server (on page 25).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 26).
4. Remove the access panel ("Access panel" on page 30).
5. Remove the SATA cable if it is clipped to the air baffle.
6. Remove the air baffle.