HP ProLiant DL360p Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 51
The server may look different than the one shown in the following illustration, depending on the server
model.
To replace the component, reverse the removal procedure.
Expansion boards
To remove the component:
1. Power down the server (on page 25).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 26).
4. Remove the access panel ("Access panel" on page 30).
5. Remove the PCIe riser cage ("PCI riser cage" on page 50).
6. Remove the expansion board.
To replace the component, reverse the removal procedure.
If you are not replacing the expansion board, install the screw back into the PCIe riser cage before installing
the PCIe riser cage back into the server.