HP ProLiant DL360p Gen8 Server Maintenance and Service Guide

Cabling 70
To install the component:
1. Power down the server (on page 25).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 26).
4. Remove the access panel ("Access panel" on page 30).
5. Disconnect any SAS cables from the hard drive cage and either the embedded SAS controller or an
optional SAS controller. Do not disconnect the power cable.
Remove two SAS cables from an SFF configuration, or one cable from an LFF configuration.
The server may look different than the one shown in the following illustrations, depending on the server
model.