HP StorageWorks All-in-One Storage Manager user guide (452695-004, November 2008)

NOTE:
Any existing iSCSI connections must be reset before changes take effect.
Resetting iSCSI connections
If you use the Storage Networks dialog box to configure a preferred private storage network for iSCSI
traffic and there are one or more existing iSCSI connections on the system, the new setting will not
take effect until the existing connections are reset through iSCSI Initiator on the connected systems.
To reset an iSCSI connection:
1. On the system that contains the iSCSI initiator whose connection has been changed, open
Microsoft iSCSI Initiator.
2. On the Persistent Targets tab, select the iSCSI target that resides on your HP Storage Server and
then click Remove.
3. On the Targets tab, select the iSCSI target that resides on your HP Storage Server and then click
Details.
4. Select the target identifier from the list, click Log off, and then click OK.
5. On the Discovery tab, under Target Portals select the IP address that was previously designated
for iSCSI traffic between the application server and the HP Storage Server and click Remove.
6. Click Add. In the IP address or DNS name field, type the IP address that was enabled for iSCSI
traffic in the All-in-One Storage Networks dialog box and then click OK.
7. On the Targets tab, click Log On.
8. Check the Automatically restore this connection when the system boots check box and then click
OK.
9. Click OK to close the iSCSI Initiator Properties dialog box.
All-in-One Storage Manager 11