HP ProLiant DL380e Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 48
7.
Remove the fan board.
To replace the component, reverse the removal procedure.
DIMMs
To remove the component:
1. Power down the server (on page 31).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 32).
o Remove the server from the rack (on page 34).
4. Remove the access panel ("Access panel" on page 37).
5. Remove the air baffle ("Air baffle" on page 41).
6. Open the DIMM slot latches.