HP ProLiant DL380e Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 71
o
Extend the server from the rack (on page 32).
o Remove the server from the rack (on page 34).
5. Remove the access panel ("Access panel" on page 37).
6. Remove the air baffle ("Air baffle" on page 41).
7. Remove the PCI riser cages ("PCI riser cage" on page 56).
8. Disconnect all cables connected to the system board.
9. Remove all DIMMs ("DIMMs" on page 48).
10. If installed, remove the heatsink blank ("Heatsink blank" on page 49).
11. Remove the heatsink:
a. Loosen one pair of diagonally opposite screws halfway, and then loosen the other pair of screws.
b. Completely loosen all screws in the same sequence.
c. Remove the heatsink from the processor backplate.