HP ProLiant Support Pack 9.10 User Guide

DescriptionReboot options
use this argument with the /reboot option, or the
argument is ignored.
Delays the reboot of the server for the length of time that
the timeout_in_seconds variable specifies. You must
/reboot_delay timeout_in_secs
use this argument with the /reboot option, or the
argument is ignored. Acceptable values are between 15
and 3600.
The default timeout value is 15 seconds for Microsoft
Windows operating systems and 60 seconds for Linux.
For Linux, the reboot delay time is converted from
seconds to minutes, and any value under a full minute
(59 seconds or less) rounds to the next minute.
If the following conditions are met, this argument forces
the server to reboot:
/reboot_always
The /reboot_always option is selected or given as
a command-line argument.
All components selected for installation are successfully
installed.
DescriptionSimulating HP SUM
Simulates the installation for a test run. Nothing is installed./dryrun
DescriptionTargets
Use this argument to log in to the remote targets by using
the user ID. For the OA target, use the /oa_username
argument.
/user<username> or /username <username>
Use this argument to use this password for the user ID
specified in the /user parameter (except for the OA
/psswd <password>
target). The password is used to log in to remote targets.
For the OA target, use the /oa_password argument.
This is the IP address or the DNS name of a remote host,
which can be a remote server, remote iLO NIC port, Virtual
/target netAddress
Connect Ethernet or Fibre Channel Module for c-Class
BladeSystem, or BladeSystem OA.
When two OAs are in an enclosure, this argument should
be the active OA. When specifying the IP address, use
either the IPv4 or IPv6 format.
Enables the credential of the local host to be used as the
credential to access the targets instead of providing the
/current_credential
user name and password explicitly for each target. The
assumption is that the current credential is valid for the
targets being accessed. (Applies to Windows only)
This argument provides the user name credential for OA
associated with VC specified with the target
/oa_username
command-line parameter. Only one set of OA credentials
can be specified with command-line parameters. You can
add multiple VC targets to command-line parameters with
the target parameter only if the credentials of OAs
associated with specified VCs are the same. The argument
oa_username is not required if VC has the same
credentials as the associated OA. You do not need to
provide an OA network address associated with VC. HP
SUM queries it from a specified VC target.
Command-line interface 23