HP StorageWorks Clustered Gateway (software-only) 3.6.0 Windows Storage Server Edition Upgrade Guide (433702-002, January 2008)

Chapter 4: Non-Rolling Upgrades 25
11. On each server in group A, install HP Clustered File System 3.6.0.
Locate the file MxS_3.6.0.<xxxx>.msi on the product CD or in the
directory where you downloaded the software. Double-click on the
MxS_3.6.0.<xxxx>.msi file and run the Installation Wizard. To complete
the installation, reboot the servers when directed by the popup
message.
12. On each server in group A, install FS Option for Windows. Insert the
product CD into the CD drive or go to the location where you have
downloaded the software. Then double-click the file
MxFS_3.6.0.<xxxx>.msi and run the Installation Wizard.
13. On each server in group A, restore the HP Clustered File System
configuration that you saved in step 2. Be sure to copy the \conf
directory back to its original location: %Program
Files%\Hewlett-Packard\HP Clustered File System\conf.
14. Start the HP CFS Management Console and enter the login credentials
for a server in group A. Click the down arrow on the Connect button
to see the options, and then click on Configure.
15. Install the new license file. On the General Settings window, select
Change License File and install the new license.
16. Click Apply on the bottom of the Cluster Configuration window. (You
may be prompted to reenter the Administrative password. You can
click Apply again if necessary to redisplay the password prompt.)
Answer No when you are asked whether you want to start the cluster.
NOTE: If the Apply fails, verify that the FC switch ports are enabled
for all of the servers. If the switch ports are enabled, check the
Windows Disk Management MMC snap-in to determine
whether the node can see the disks on the SAN. Also check the
HBA driver.
17. Go to the Cluster Wide Configuration tab and export the updated
configuration to all other servers in group A.