HP StorageWorks X5500 Network Storage Gateway for Windows setup guide (AP809-96004, October 2009)

Chapter3:SettingUpHPStorageWorksClusteredFileSystem 25
1. SANSwitches.SpecifythehostnamesorIPaddressesofthe
FibreChannelswitchesthataredirectlyconnectedtothenodesinthe
cluster.ClickAdd,andthenspecifythehostnameorIPaddressofthe
firstFCswitch.RepeatthisproceduretospecifytheremainingFC
switches,includingcascadingswitches.If
youareusinganMPIO
configuration,besuretoconfigurealloftheswitches.
2. SNMPCommunityString.ThedefaultSNMPcommunity stringfor
HPClusteredFileSystemisprivate.Ifyouwanttouseacustom
communitystring,entertheappropriatevaluehere.TheSNMP
communitystringmustbeset
tothesamevalueonHPClusteredFile
SystemandontheSANswitchesconfiguredabove.
Whenyouhavecompletedtheinformation,gototheStorageSettingstab.
WebManagement‐BasedFencing
WhenyouselecteitheriSCSIstorageorFibreChannelstoragewithWeb
management‐basedfencing,theSAN&Fencingtabwill
refreshandask
youforconfigurationinformation.Entertheappropriateinformationfor
theRemoteManagementControllerassociatedwiththeserverthatyou
usedtoconnecttotheManagementConsole.
NOTE: Laterinthisprocedurethecompleteclusterconfigurationwillbe
exportedtotheotherserversthatwillbeinthecluster.Duringthe
export,HPClusteredFileSystemwill,wherepossible,usethe
informationthatyouspecifiedontheSAN&Fencingtabto
configureWebmanagement‐basedfencingonthe
otherservers.If
aparticularentryontheSAN&Fencingtabdidnotapplytoall
servers,HPClusteredFileSystemwillaskforthatinformationfor
eachoftheotherservers.