HP StorageWorks X5500 Network Storage Gateway for Windows setup guide (AP809-96004, October 2009)

Chapter3:SettingUpHPStorageWorksClusteredFileSystem 34
1. Addserverstothecluster.Tospecifythefirstserver,clickAddServer
andtypetheIPaddressorhostnameoftheserverontheInputform.
ThenclickOKtoaddtheservertotheAddresscolumn.
RepeatthisproceduretoaddtheremainingserverstotheAddress
column.
2. Export
theconfiguration.ClickSelectAlltoselectalloftheserversin
theAddresscolumn.ThenclickExport.TheLastOperationProgres s
columnwilldisplaystatusmessagesastheconfigurationisexported
toeachserver.
IfyouareusingWebManagement‐basedfencing,youmaybeasked
foradditionalinformationabout
eachserver.Basedontheentriesyou
madeontheFencingtab,theinformationcanincludeanyorallofthe
following:thevendor/typefortheRemoteManagementController,
theIPaddress/hostnameoftheRemoteManagementController,the
usernameandpasswordfortheRemoteManagementController.
NOTE: IfyouareusingWebmanagement‐basedfencing,youshould
nowverifythattheremotemanagementcontrolleris
configuredcorrectly.See“TesttheFencingConfiguration”on
page35formoreinformation.DonotstartHPClusteredFile
Systemuntilyouhavecompletedtheverification.
3. StartHPClusteredFileSystemonthe
remainingservers.The
serverstowhichyouexportedtheconfigurationwillstillbeselected 
intheAddresscolumn.ClickStartServicetostartHPClusteredFile
Systemonthoseservers.Aseachserverisstarted,astatusmessage
willappearintheLastOperationProgresscolumn.(Ifyouareusing
Webmanagement‐basedfenci ng,alsostartHPClusteredFileSystem
onthefirstserver.)