HP StorageWorks X5500 Network Storage Gateway for Windows setup guide (AP809-96004, October 2009)

Chapter4:OtherProcedures 40
“No Mapping/Masking” Mode
AllserversthatcantargettheMAGNITUDEdevicecanalsoseeallofthe
LUNsonthedevice.HPClusteredFileSystemcanbeinstallednormally
withthisconfiguration.However,youwillneedtosetuptheLUNsthat
willbeusedwithHPClusteredFileSystembeforeyoubegintheHP
ClusteredFileSysteminstallation.For
informationabouttheLUNs
requiredforHPClusteredFileSystemoperations,see“12.CreateLUNs
fortheMembershipPartitionsandModifyPartitionTables”onpage16.
“New Server See Nothing” Mode
OnlythoseserversthathavebeenidentifiedbytheMAGNITUDEstorage
arrayareallowedtoseespecificallym appedLUNs.Thestoragearray
usestheWWIDoftheFCHostBusAdaptertomanagethismodeof
operation.
BeforeinstallingHPClusteredFileSystem,youwillneedtoperformthe
followingprocedure,whichensuresthattheLUNsareavailablewhen
youconfigure
HPClusteredFileSystem.
Completethefollowingsteps:
1. SetuptheLUNsthataregoingtobeusedbyHPClusteredFile
System.(See“12.CreateLUNsfortheMembershipPartitionsand
ModifyPartitionTables”onpage16.)
2. Whenbootingeachserver,pressCtrl‐QtoentertheQLogicSetup
Program.
3. Select
“ScanforFibreDevices”fromthemenu.
4. Pagethroughtheresultsuntilyouseethe
MAGNITUDEdevice.
5. Onthe
MAGNITUDEdevice,maptheLUNstotheWWIDs.
ExittheQLogicSetupProgram.Theserverwillrebootautomatically.