HP ProLiant DL380p Gen8 Server Maintenance and Service Guide

Removal and replacement procedures 32
2.
After the display fully ejects, rotate the display downward to view the LEDs.
Release the full-length expansion board retainer
To remove the component:
1. Power down the server (on page 28).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend ("Extend the server from the rack" on page 29) or remove ("Remove the server from the rack" on
page 30) the server from the rack.
4. Remove the access panel ("Access panel" on page 34).
5. Release the full-length expansion board retainer.
To replace the component, reverse the removal procedure.