HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages

HP Onboard Administrator errors 194
OA: PS Subsystem N + N Redundancy - FAILED.
OA: PS Subsystem Overload - FAILED.
OA: PS Subsystem Overload – REPAIRED.
OA: PS Subsystem Power Limit - FAILED.
OA: PS Subsystem Power Limit – REPAIRED.
OA: Redundant Onboard Administrator was removed
OA: Required fan is missing from fan bay [value]
OA: The fan in bay #[value:fanNumber] is not supported in this enclosure. Please
replace this fan with the proper part number.
OA: The power management controller firmware on blade [value:bladeNumber] must
be upgraded. Please see customer advisory c01668472.
OA: TRAY microcode update failed
Log type: LOG_NOTICE, Failure type: SW
OA: Blade [value:bladeNumber] and its partner device need be powered up in a
different order.
OA: Blade [value:bladeNumber] cannot be managed as part of the Enclosure Dynamic
Power Cap. The blade's iLO firmware version is [value:version] and version
[value:version] is required.
OA: Blade [value:bladeNumber] cannot be powered on at this time due to location
rules.
OA: Blade [value:bladeNumber] has been allocated a default power value of [value]W
because iLO appears unresponsive.
OA: Blade [value:bladeNumber] is missing a Scalable Blade Link.
OA: Blade [value:bladeNumber] is not configured for Virtual Connect Manager.
OA: Blade [value:bladeNumber] requires a proper mezzanine card to partner.
OA: Blade [value:bladeNumber] requires partner in bay [value:bladeNumber] to be
powered on first.
OA: Blade [value:bladeNumber]: SMBIOS data carries more than [value] CPU records
which cannot be processed with this OA firmware version.
OA: Blade [value:bladeNumber]: SMBIOS data carries more than [value] DIMM records
which cannot be processed with this OA firmware version.
OA: Blade [value:bladeNumber]: SMBIOS data carries more than [value] NIC records
which cannot be processed with this OA firmware version.
OA: Blade [value:bladeNumber]: SMBIOS data requires [value] DIMM records. [value]
are supported by this OA firmware version.
OA: Enclosure Dynamic Power Cap: Device tray firmware doesn't meet minimum
required version.
OA: Enclosure Dynamic Power Cap: Server Power Reduction is not enabled; enclosure
cap is not guaranteed if power redundancy is lost.
OA: Fan Inserted: Bay #[value:fanNumber]
OA: iLO in bay [value:bladeNumber] appears responsive to the Enclosure Dynamic
Power Cap again.
OA: iLO in bay [value:bladeNumber] is not responding to capping requests from
the Enclosure Dynamic Power Cap. Reset the iLO.