HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages

HP Onboard Administrator errors 200
Redundancy: WARNING: The other OA ([Standby/Active]) is running a different
firmware. OA Redundancy will be degraded
Log type: LOG_NOTICE, Failure type: SW
Redundancy: Assuming active Onboard Administrator network settings.
Redundancy: Enclosure IP mode was [disabled/enabled]
Log type: LOG_INFO, Failure type: SW
Redundancy: Enclosure IP mode configurations have been reset.
Redundancy: Onboard Administrator has now completed the Standby to Active
transition
Redundancy: Onboard Administrator redundancy restored.
Redundancy: Service started ([ACTIVE/STANDBY])
SSO log messages
Log type: LOG_WARNING, Failure type: Info
OA: HP SSO [value] logged into the Onboard Administrator
OA: HP SSO [value] logged into the Onboard Administrator from
[value:remoteAddress]
Log type: LOG_NOTICE, Failure type: Info
OA: Authentication failure for user HP SSO [value]
OA: Authentication failure for user HP SSO [value] from [value:remoteAddress]
OA: HP SSO Trust Mode changed to [value] by user [value:username].
Two-factor log messages
Log type: LOG_WARNING, Failure type:SW
OA: Two Factor: Two-Factor authentication failed for user at [value]: local user
certificate status check failed.
Log type: LOG_WARNING, Failure type: Info
OA: Two Factor: [value:username] logged into the Onboard Administrator from
[value] using Two-Factor
OA: Two Factor: [value:username] logged into the Onboard Administrator from
Enclosure Link using Two-Factor
OA: Two Factor: Unable to create session for user [value:username]: the maximum
number of sesssions has been reached.
Log type: LOG_CRIT, Failure type: SW
OA: Two Factor: Two-Factor authentication failed for user at [value]: the
certificate provided could not be authenticated.
Log type: LOG_ERR, Failure type: SW
Two Factor: Error allocating memory.
Two Factor: Error creating place holder for CRL
Two Factor: Error creating temp store for CRL