HP ProLiant Gen8 Troubleshooting Guide Volume II: Error Messages

HP Onboard Administrator errors 201
Two Factor: Error downloading CRL from [value:URL]
Two Factor: Error mapping CRL files.
Two Factor: Error starting CRL service.
Two Factor: Insufficient privileges.
Two Factor: Internal error.
Two Factor: Invalid/corrupt CRL file at [value:URL]
Two Factor: Messaging system error.
FIPS log messages
Log type: LOG_INFO, Failure type: SW
FIPS: Onboard Administrator is operating in FIPS Mode Debug.
FIPS: Onboard Administrator is operating in FIPS Mode On.
FIPS: Too many Known Answer Test (KAT) failures: left FIPS mode
FIPS: "Last reboot was due to a Known Answer Test (KAT) failure.
Log type: LOG_ERR, Failure type: SW
OA: Error restoring factory default settings. Restoring FIPS mode...
OA: Failed to restore FIPS mode for standby Onboard Administrator.
OA: Could not restore FIPS mode (error code: [value]).
OA: Could not restore the password for user [value].
OA: Could not restore the strict passwords setting.
OA: Could not restore the minimum password length.
OA: Could not restore the password for user [value].
VLAN log messages
Log type: LOG_NOTICE, Failure type: Info
OA: May need to reboot the interconnects to pick up new IP address or wait until
DHCP lease expires
OA: VLAN ID for interconnect bay [value] changed to [value]. May need to reboot
the interconnect to pick up new IP address or wait until DHCP lease expires
OA: VLAN ID for OA changed from [value] to [value]
OA: VLAN ID for server bay [value] changed to [value]
OA: VLAN is disabled
OA: VLAN is enabled. OA VLAN ID = [value]
Log type: LOG_INFO, Failure type: Info
OA: VLAN revert is canceled
Onboard Administrator SNMP traps
The BladeSystem Onboard Administrator supports the following SNMP traps.